▶
Push the locking latch in the direction of the arrow to lock the front panel
module.
Figure 295: Connecting the cables to the RDX drive
▶
Connect the power cable to the RDX drive (1).
▶
Connect the end of the power cable to connector "PWR6" on the system
board.
▶
Connect the USB cable to the RDX drive (2).
▶
Connect the end of the USB cable to connector "USB 3.0" (see close-up) on
the system board.
Concluding steps
▶
"Installing the fan cage" on page
77.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
Accessible drives
444 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
