▶
Insert the front VGA cable from the server inside through the opening.
▶
Fasten the front VGA connector with the two screws (see circles).
Figure 319: Installing the front VGA cable
▶
Insert the front VGA cable in the cable clip (1).
▶
Connect the front VGA cable to the system board connector "FRONT VGA"
(2).
Concluding steps
▶
"Installing the air duct" on page
79.
▶
"Installing the fan cage" on page 77.
▶
If applicable, "Installing the riser module 1" on page 74.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
Front panel
472 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
