Tools: Removing the system board:
–
Phillips PH2 / (+) No. 2 screw driver
– Torx 30 screw driver
Replacing the TPM:
– Bit screw driver
–
TPM bit insert
(*)
– flat nose pliers
–
thin slotted screw driver (2 x 0.4 mm)
(*)
(*)
For Japan:
– TPM module fixing tool (S26361-F3552-L909)
– Dedicated TPM screw driver (CWZ8291A)
CAUTION
▶
Advise your contact persons that they must provide you with all
recovery keys which belong to the system to restore them in the
TPM later
.
Preliminary steps
▶
"Locating the defective server" on page
47.
▶
"Suspending BitLocker functionality" on page 89.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
Remove all PSUs, see "Removing a hot-plug PSU" on page 129.
▶
If applicable, remove the OCP module, see "Removing an OCP module" on
page 265.
▶
"Getting access to the component" on page 55.
▶
Remove all riser modules, see "Removing a riser module" on page 72.
System board and components
502 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
