GERAFT LOGIQ P9/P7
D
IRECTION 5604324, REVISION 11 DRAFT (JANUARY 24, 2019) SERVICE MANUAL
5-96 Section 5-11 - Common Service Desktop (R3 only)
SSH
SSH displays the status of the Secure Shell (SSH) server. SSH is a cryptographic network protocol for
operating network services securely over an unsecured network. This protocol is used for remote login
to the operational system. SSH allows remote login to the LOGIQ P9/P7 and remote file transfer from
the LOGIQ P9/P7. Remotely log into the LOGIQ P9/P7 using the username “GEService” and its
password.
The information on SSH is available to Class M licenses.
To access SSH, select Utility > Service > Utilities > SSH.
Figure 5-64 SSH
This table shows all the elements available on SSH with descriptions.
To start the SSH server:
1.) Navigate to Utility > Service > Utilities > Disruptive Mode Utility and set Disruptive mode to On.
2.) Navigate to Utility > Service > Utilities > SSH.
3.) Click Start.
4.) To stop the SSH server, select Stop.
For more information, see:
• Utilities on page 5-73
Table 5-41 SSH
Element DESCRIPTION
Status
When Disruptive mode is on, displays the status of the SSH server. Valid values are:
• SSH is stopped
• SSH is running
Start When Disruptive mode is ON, start the SSHD service.
Stop
When Disruptive mode is ON and the SSHD service is running, stops the SSHD
service.