C-3
Adjust the blade length manually ....................................................2-46
2.11 Running Cutting Tests ....................................................... 2-47
Cutting test .....................................................................2-47
To make 1 cut with set value ........................................................2-47
To make 3 cuts with set value and ±1 of set value .........................................2-48
Confirm the results of the cutting test.................................................2-50
Adjustment of Offset ..............................................................2-50
Adjustment for Half Cutting .........................................................2-50
Adjustment for cutting out ..........................................................2-50
Adjustment when using plotting pen ...................................................2-50
Adjust the blade length (Automatic Height Adjust) .......................................2-51
2.12 Displaying Cutting Area ..................................................... 2-53
Chapter 3: Basic Operations
3.1 Raise or Lower the Tool ....................................................... 3-2
3.2 Move the Tool Carriage ....................................................... 3-3
Move in steps manually ............................................................3-3
Continuously move manually ........................................................3-3
Setting step movement distance .....................................................3-4
Move away the tool carriage.........................................................3-5
Reset (Revert to the initial state when the power was turned on.) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-6
3.3 Setting the Origin Point ........................................................3-7
When coordinate axes rotation are set.................................................3-8
When coordinate axes are rotated after origin point is set ..................................3-8
Setting origin point when HP-GL is set.................................................3-9
3.4 Setting the Cutting Direction .................................................3-10
3.5 Stop Cutting ..................................................................3 -11
Pause and resume cutting .........................................................3 -11
Stop cutting.....................................................................3-12
Chapter 4: Convenient Functions
4.1 Settings for Cutting ........................................................... 4-2
Setting cutting area ...............................................................4-2
Setting cutting width (EXPAND) .....................................................4-4
Setting length of the page...........................................................4-5
Setting mirror ....................................................................4-6
Set the enlarge/shrink scale (Scale) ...................................................4-7
4.2 Copy (Duplicate Cutting) ...................................................... 4-9
When media change mode is OFF .....................................................4-9
When media change mode is ON .....................................................4-12
4.3 Panel Cutting .................................................................4-14
Chapter 5: ARMS
(Advanced Registration Mark Sensing System)
5.1 Outline of ARMS .............................................................. 5-2
Shape (Pattern) of the Registration Mark and Origin Point .................................5-3
Scan Range Necessary to Detect the Registration Mark...................................5-4
To Next Page
Loading...
