GRAPHTEC CE8000 Series - Page 13

C-4
Positioning of the Media and the Registration Mark.......................................5-6
Cutting area when adjusting the registration mark ........................................5-6
Automatic detection of registration mark position.........................................5-7
Media That Registration Mark Cannot be Detected .......................................5-7
5.2 Setting and Adjustment of ARMS ............................................. 5-8
Automatically adjust the registration mark sensor level ....................................5-8
Manually adjust the registration mark sensor level.......................................5-10
Test the registration mark sensor ....................................................5-12
Adjust for the registration mark scan position ..........................................5-14
Adjust after plotting the correction registration mark........................................5-14
Adjust using plotted adjustment registration mark .........................................5-16
Set the registration mark automatic detection ..........................................5-19
Set speed of the registration mark scan ...............................................5-20
Chapter 6: Manual Position Adjust
6.1 Outline of Manual Position Adjust ............................................ 6-2
Setting mark scan mode and number of adjustment marks.................................6-2
Adjust with 2 POINTS..............................................................6-2
Adjust with 3 POINTS..............................................................6-3
Adjust with 4 POINTS..............................................................6-3
6.2 Manual Position Adjust ....................................................... 6-4
Chapter 7: Settings Regarding Cutting Quality
7.1 Cutting the Corner of Thick Media Sharp ......................................7-2
Outline of tangential mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-2
Setting the tangential mode .........................................................7-3
Setting the length of overcut.........................................................7-4
Setting of the Initial Down Force......................................................7-5
7.2 Setting the Step Pass ..........................................................7-7
7.3 Setting the Offset Angle .......................................................7-9
7.4 Setting the Distance Adjust ...................................................7-11
7.5 Setting Cut Line Pattern ......................................................7-13
7.6 Setting Initial Blade Control Position Adjust ..................................7-16
7.7 Setting the blade control force ................................................7-18
7.8 Setting Adjustment Between the Tools .......................................7-20
Chapter 8: Settings Regarding Cutting Time
8.1 Sorting the Cutting Data ...................................................... 8-2
8.2 Perform Automatic Pre Feed When Cut Data is Received ........................ 8-3
8.3 Setting Feed Speed for Pre Feed ............................................. 8-5
8.4 Setting the Moving Speed .................................................... 8-6
8.5 Setting the Shortcut Move .................................................... 8-8
8.6 Setting the Tool Up Height .................................................... 8-9