Function Blocks
CALEVT Calendar Event Function Block
90 HC900 Hybrid Control Designer Function Block Reference Guide Revision 11
2/07
SPGRP = Value of Event Set point that is to be loaded {range 1 to 5} When SPGRP is connected to a
variable, toggling the ^SET input is not required; the setpoint group is loaded automatically.
^SET = Loads the event set point group as indicated by the spgrp input signal.
SPGRP and ^SET input pins allow the user to activate one of five Setpoint Groups at any time. All the 8
events will be activated based on the settings in this Setpoint Group.
Output
OUT1 =
Calendar timer event 1 output
OUT2 = Calendar timer event 2 output
OUT3 = Calendar timer event 3 output
OUT4 = Calendar timer event 4 output
OUT5 = Calendar timer event 5 output
OUT6 = Calendar timer event 6 output
OUT7 = Calendar timer event 7 output
OUT8 = Calendar timer event 8 output
Note: If the Event occurs when the Controller is OFF or not in RUN MODE, the event output will not turn
ON until the event occurs again and the Controller is in RUN MODE
SPGRP =
Value of Event Set point that was loaded {range 1 to 5} at the SPGRP input pin.
BAD_CLK = Bad clock; on when error in system time.
Configuration Parameters
The CALEVT properties dialog box is divided into 7 tab cards:
EVENT DETAILS
SPECIAL DAYS
EVENT SETPOINT 1
EVENT SETPOINT 2
EVENT SETPOINT 3
EVENT SETPOINT 4
EVENT SETPOINT 5
Click on the tab to access the properties for that tab.
To Next Page
Loading...
Need help?
General
