Honeywell HC900 - Table 66 on Delay Timer Function Block Example

Function Blocks
ONDT On Delay Timer Function Block
226 HC900 Hybrid Control Designer Function Block Reference Guide Revision 11
2/07
Block properties
Double click on the function block to access the function block properties dialog box.
Configuration parameters
Table 66 On delay timer function block example
Properties Group Parameter Index # Parameter Description Value or Selection
Time Delay Time delay
0
Delay Time - specifies the
amount of time the ON state logic
output will occur after an OFF to
ON transition of the RUN input.
0.1 sec, 0 to 99999.9
Enter as 0.1 to 99999 in
0.1 increments