Honeywell HC900 - SW Analog Switch Function Block

Function Blocks
SW Analog Switch Function Block
378 HC900 Hybrid Control Designer Function Block Reference Guide Revision 11
2/07
SW Analog Switch Function Block
Description
The SW label stands for Analog Switch.
This block is part of the
Signal Selectors category.
Function
Selects input Y for output when digital input signal (SY) is ON.
• If SY = ON, then; OUT = Y
• Otherwise, OUT = X
Input
X
= First analog value
Y = Second analog value
SY = Where ON selects Y command digital signal.
Output
OUT
= Selected value
Block properties
Double click on the function block to access the function block properties dialog box.