Honeywell HC900 - Table 6 AGA8 GS General Tab Configuration Parameters

Function Blocks
AGA8GS Function Block
24 HC900 Hybrid Control Designer Function Block Reference Guide Revision 11
2/07
GENERAL tab
Table 6 AGA8GS General tab configuration parameters
Properties Group Parameter Index # Parameter Description Value or Selection
Block Order
Execution Order for Block
Execution Order of this block
must be set to be less than
meter block (AGA3, 7, or 9)
Execution Order for correct
calculation sequence.
Read Only. To change
block order, right-click on
a Function Block and
select Execution Order.
Tag Name
N/A 16-character tag name
Block
Descriptor
N/A Block description