Honeywell HC900 - Table 74 PDE General Tab Configuration Parameters

Function Blocks
PDE Peer Data Exchange Function Block
Revision 11 HC900 Hybrid Control Designer Function Block Reference Guide 255
2/07
Block Properties
Double click on the function block to access the function block properties.
Block properties
Double click on the function block to access the function block properties dialog box.
Dialog box structure
The PDE properties dialog box is divided into 3 tab cards
GENERAL
READ
WRITE
Click on the tab to access the properties for that tab.
GENERAL tab
Table 74 PDE General tab configuration parameters
Parameter Index # Parameter Description Value or Selection
Peer
Controller
Name
N/A
Name of the Peer
controller for this block
Enter the peer controller name in the
active field. 12 characters max.
Scan Rate
for Reads
N/A
Set to equal to or
greater than 2X the
analog cycle scan rate
of the peer device.
Scan rate selection for
reads:
0.25 seconds
0.5 seconds
1.0 seconds
5.0 seconds
Click on radio button to select