Honeywell HC900 - Table 3 AGA8 DL General Tab Configuration Parameters

Function Blocks
AGA8DL Function Block
Revision 11 HC900 Hybrid Control Designer Function Block Reference Guide 15
2/07
Configuration parameters
The AGA8DL properties dialog box is divided into two tab cards
GENERAL
AGA8 - Detail
Click on the tab to access the properties for that tab.
GENERAL tab
Table 3 AGA8DL General tab configuration parameters
Properties Group Parameter Index # Parameter Description Value or Selection
Block Order
Execution Order for Block
Execution Order of this block
must be set to be less than
meter block (AGA3, 7, or 9)
Execution Order for correct
calculation sequence.
Read Only. To change
block order, right-click on
a Function Block and
select Execution Order.
Tag Name
N/A 16-character tag name
Block
Descriptor
N/A Block description