Honeywell HC900 - Table 120 TPSC RSP Tab Configuration Parameters

Function Blocks
TPSC (3POS) Function Block
414 HC900 Hybrid Control Designer Function Block Reference Guide Revision 11
2/07
RSP tab
Table 120 TPSC RSP tab configuration parameters
Properties Group Parameter Index # Parameter Description Value or Selection
Remote Setpoint
Source and Units
Use RSP
Input (EU)
N/A
Use Remote Setpoint in
Engineering Units
Click on radio button to select
Use RSP
Input (%)
N/A
Use Remote Setpoint in
Percent
Click on radio button to select
Use LSP2
(EU)
N/A
Use Local Setpoint #2 in
Engineering Units
Click on radio button to select
No Ratio or
Bias
N/A
No ratio and bias applied
to the function block
Click on radio button to select
Use Local
Bias
N/A
Use Bias value selected
on Tab
Click on radio button to select
Enter value at “
Local Bias
Value
” on tab.
Use Bias
Input
N/A
Use Bias value attached to
an input to the block
Click on radio button to select
Local Bias
Value (EU)
46
Local bias value in
engineering units
Enter local bias value
–99999 to 99999
Ratio/Bias
(RSP Input Only)
Ratio
45 Gain value for Ratio PID –20 to +20