Revision 11 HC900 Hybrid Control Designer Function Block Reference Guide iii
2/07
About This Document
Abstract
The "Hybrid Control Designer" configuration software program is used for HC900 Controller and Operator
Interface configuration and operates on a PC with Windows 2000 or XP. The software program uses graphic
symbols and line drawing connections to create custom control strategies. Menus are provided in the software to
allow selection of screens for the operator interface and to customize screen access methods and operator keys.
Completed configurations are loaded into the control system using a dedicated communication port in the controller.
References
The following list identifies all documents that may be sources of reference for material discussed in this
publication.
Document Title Doc ID
HC900 Controller Technical Overview 51-52-03-31
HC900 Controller Installation and User Guide 51-52-25-107
HC900 Operator Interface User Guide 51-52-25-108
HC900 Hybrid Control Designer User Guide
HC900 Hybrid Controller Communications User Guide
51-52-25- 110
51-52-25-111
Contacts
World Wide Web
The following lists Honeywell’s World Wide Web sites that will be of interest to our customers.
Honeywell Organization WWW Address (URL)
Corporate
http://www.honeywell.com
Industrial Measurement and Control
http://www.hpsweb.honewell.com
IM&C Technical tips
http://content.honeywell.com/ipc/faq
Telephone
Contact us by telephone at the numbers listed below.
Organization Phone Number
United States and Canada Honeywell
1-800-423-9883 Tech. Support
1-800-525-7439 Service
To Next Page
Loading...
