Honeywell HC900 - Page 355

Function Blocks
SPEV Setpoint Programming Event Decoder Function Block
Revision 11 HC900 Hybrid Control Designer Function Block Reference Guide 341
2/07
ATTENTION
SPEV inputs must be connected directly to corresponding outputs of SPP (Setpoint Program)
or SPS (Setpoint Scheduler) block.
In Stop state, events stay in the state defined in the last segment.
Outputs
E1
= Digital signal - segment event 1
E2 = Digital signal - segment event 2
E3 = Digital signal - segment event 3
E4 = Digital signal - segment event 4
E5 = Digital signal - segment event 5
E6 = Digital signal - segment event 6
E7 = Digital signal - segment event 7
E8 = Digital signal - segment event 8
E9 = Digital signal - segment event 9
E10 = Digital signal - segment event 10
E11 = Digital signal - segment event 11
E12 = Digital signal - segment event 12
E13 = Digital signal - segment event 13
E14 = Digital signal - segment event 14
E15 = Digital signal - segment event 15
E16 = Digital signal - segment event 16
Block properties
Double click on the function block to access the function block properties dialog box.