HP E4418B - SCPI Compliance Information

prog.book : chapter1.fm 111 Mon Feb 15 09:24:37 1999
Power Meter Remote Operation
SCPI Compliance Information
HP E4418B/E4419B Programming Guide 1-111
SCPI Compliance Information
The power meter complies with the rules and regulations of the present
version of SCPI (Standard Commands for Programmable Instruments).
You can determine the SCPI version with which the power meter’s is in
compliance by sending the SYSTem:VERSion? command from the remote
interface.
The following commands are device-specific to the HP E4418B/E4419B.
They are not included in the 1996.0 version of the SCPI standard.
However, these commands are designed with the SCPI format in mind and
they follow all of the syntax rules of the standard.
CALibration[1|2]:ECONtrol:STATe
CALibration[1|2]:RCALibration
CALibration[1|2]:RCFactor
DISPlay[:WINDow[1|2]]:FORMat
DISPlay[:WINDow[1|2]]:METer:LOWer
DISPlay[:WINDow[1|2]]:METer:UPPer
DISPlay[:WINDow[1|2]]:RESolution
DISPlay[:WINDow[1|2]]:SELect
MEMory:CLEar[:NAME]
MEMory:TABLe:SELect
MEMory:STATe:DEFine
MEMory:TABLe:GAIN[:MAGNitude]
MEMory:TABLe:GAIN:POINts?
MEMory:TABLe:MOVE
OUTPut:TTL[1|2]:ACTive
OUTPut:TTL[1|2]:FEED
OUTPut:TTL[1|2]:STATe
[SENSe[1]]|SENSe2:AVERage:SDETect
[SENSe[1]]|SENSe2:CORRection:CFACtor
[SENSe[1]]|SENSe2:CORRection:DCYCle
[SENSe[1]]|SENSe2:CORRection:FDOFfset
[SENSe[1]]|SENSe2:SPEed
[SENSe[1]]|SENSe2:POWer:AC:RANGe
SERVice:SENSor[1|2]:CDATE?
SERVice:SENSor[1|2]:CPLace?
SERVice:SENSor[1|2]:SNUMber?
SERVice:SENSor[1|2]:TYPE?
SYSTem:LOCal
SYSTem:REMote
SYSTem:RINTerface