prog.book : ch7mem.fm 11 Mon Feb 15 09:24:37 1999
MEMory Subsystem
MEMory:CLEar:TABLe
HP E4418B/E4419B Programming Guide 7-11
MEMory:CLEar:TABLe
This command is used to clear the contents of the table currently selected
using MEMory:TABLe:SELect. Although the table remains, a
MEMory:TABLe:FREQuency|GAIN:POINts? query returns a 0 as there
are no contents in the table.
This command is an alternative form of the MEMory:CLEar[:NAME]
command, the only difference being the method in which the table is
selected.
Note The contents cleared using this command are non-recoverable.
Syntax
Example
Error Message
If no table is selected, error -221, “Settings conflict” occurs.
MEM:CLE:TABL This command clears the contents
of the currently selected table.
MEM
:CLE
:TABL
To Next Page
Loading...
