HP E4418B - System:communicate:serial Node

prog.book : ch11syst.fm 4 Mon Feb 15 09:24:37 1999
SYSTem Subsystem
SYStem:COMMunicate:Serial Node
11-4 HP E4418B/E4419B Programming Guide
SYStem:COMMunicate:Serial Node
This node controls the settings for the RS232/RS422 serial interface. The
commands allow you to:
• Set the function of the DTR and RTS signal lines
• Set the transmit/receive baud rate
• Set the transmit/receive word length
• Set the transmit/receive parity type
• Set the transmit/receive stop bits
• Enable /disable XON/XOFF software handshaking
The commands accociated with this node are:
SYSTem:COMMunicate:SERial:CONTrol:DTR
SYSTem:COMMunicate:SERial:CONTrol:RTS
SYSTem:COMMunicate:SERial:[:RECeive]:BAUD
SYSTem:COMMunicate:SERial:[:RECeive]:BITs
SYSTem:COMMunicate:SERial:[:RECeive]:PACE
SYSTem:COMMunicate:SERial:[:RECeive]:PARity:[TYPE]
SYSTem:COMMunicate:SERial:[:RECeive]:SBITs
SYSTem:COMMunicate:SERial:TRANsmit:AUTO?
SYSTem:COMMunicate:SERial:TRANsmit:BAUD
SYSTem:COMMunicate:SERial:TRANsmit:BITs
SYSTem:COMMunicate:SERial:TRANsmit:ECHO
SYSTem:COMMunicate:SERial:TRANsmit:PARity:[TYPE]
SYSTem:COMMunicate:SERial:TRANsmit:SBITs