prog.book : ch9sens.fm 43 Mon Feb 15 09:24:37 1999
SENSe Subsystem
[SENSe[1]]|SENSe2:LIMit:FAIL?
HP E4418B/E4419B Programming Guide 9-43
[SENSe[1]]|SENSe2:LIMit:FAIL?
This query enters a 1 or 0 into the output buffer indicating whether there
have been any limit failures for the specified channel. A limit failure is
defined as [SENSe[1]]|SENSe2:LIMit:FCO? being non-zero. The FCO
(fail counter) can be zeroed using the
[SENSe[1]]|SENSe2:LIMit:CLEar command.
• 1 is returned when one or more limit failures have occurred.
• 0 is returned when no limit failures have occurred.
Syntax
Example
Reset Condition
On reset, the buffer is set to zero for both channels.
SENS1:LIM:FAIL? This command queries if there
have been any limit failures on
channel A.
LIM
:FAIL
?
SENS
1
SENS2
:
To Next Page
Loading...
