prog.book : ch15ieee.fm 10 Mon Feb 15 09:24:37 1999
IEEE488.2 Command Reference
*ESE <NRf>
15-10 HP E4418B/E4419B Programming Guide
*ESE <NRf>
The *ESE (Event Status Enable) <NRf> command sets the Standard
Event Status Enable Register. This register contains a mask value for the
bits to be enabled in the Standard Event Status Register. A 1 in the
Enable Register enables the corresponding bit in the Status Register, a 0
disables the bit. The parameter value, when rounded to an integer and
expressed in base 2, represents the bit values of the Standard Event
Status Enable Register. Table 15-3 shows the contents of this register.
Table 15-3: *ESE Mapping
Syntax
Parameters
Query
*ESE?
The query returns the current contents of the Standard Event Status
Enable Register. The format of the return is <NR1> in the range of
0 to 255.
Bit Weight Meaning
0 1 Operation Complete
1 2 Request Control (not used)
2 4 Query Error
3 8 Device Dependent Error
4 16 Execution Error
5 32 Command Error
6 64 Not used
7 128 Power On
Type Description/Default
Range of
Values
NRf A value used to set the Standard Event
Status Enable Register.
0 to 255
*ESE
NRf
?
Space
To Next Page
Loading...
