To Next Page

To Previous Page

prog.book : ch9sens.fm 29 Mon Feb 15 09:24:37 1999

SENSe Subsystem

[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe <Boolean>

HP E4418B/E4419B Programming Guide 9-29

[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe <Boolean>

This command is used to enable and disable a channel offset for the power

meter setup. Since GAIN2 and LOSS2 form a coupled system, the

command is identical to

[SENSe[1]]|SENSe2:CORRection:LOSS2:STATe.

The [SENSe[1]]|SENSe2:CORRection:GAIN2 command should be used

to enter the gain value.

Syntax

Example

Reset Condition

On reset, channel offsets are disabled.

Query

[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe?

The query enters 1 or 0 into the output buffer indicating the status of the

channel offsets.

• 1 is returned if a channel offset is enabled.

• 0 is returned if a channel offset is disabled.

Query Example

CORR:GAIN2:STAT ON This command enables a channel

offset on channel A.

CORR:GAIN2:STAT? This command queries whether or

not there is a channel offset

applied to channel A.

SENS

:GAIN2

CORR

SENS2

:STAT

0|OFF

1|ON

Space

HP E4418B Programming Guide

Other manuals for HP E4418B