To Next Page

To Previous Page

prog.book : ch7mem.fm 26 Mon Feb 15 09:24:37 1999

MEMory Subsystem

MEMory:TABLe:GAIN[:MAGNitude] <numeric_value>{,<numeric_value>}

7-26 HP E4418B/E4419B Programming Guide

MEMory:TABLe:GAIN[:MAGNitude] <numeric_value>{,<numeric_value>}

This command is used to enter calibration factors into the sensor

calibration table, or offsets into the frequency dependent offset table,

currently selected using MEMory:TABLe:SELect. Any previous

calibration factor list, or offset list is cleared before the new calibration

factors/offsets are stored.

A maximum of 81 parameters for sensor calibration tables and 80

parameters for frequency dependent offset tables can be sent with this

command. For sensor calibration tables only, the ﬁrst parameter is the

reference calibration factor, each subsequent parameter is a calibration

factor point in the sensor calibration table.

Entries in the frequency lists correspond as shown with entries in the

calibration/offset factor lists.

For sensor calibration tables the number of frequency points must be one

less than the number of calibration factor data points. This is veriﬁed

when the sensor calibration table is selected using

SENSe:CORRection:CSET1:SELect <string>.

Syntax

Calibration Factor/Offset Frequency

Reference Calibration Factor

(Sensor Cal Table Only)

Calibration Factor/Offset 1 Frequency 1

Calibration Factor/Offset 80 Frequency 80

MEM

:TABL

:GAIN

:MAGN

numeric_value

Space

HP E4418B Programming Guide

Other manuals for HP E4418B