HP E4418B - Status Subsystem

prog.book : chapter1.fm 108 Mon Feb 15 09:24:37 1999
Power Meter Remote Operation
Quick Reference
1-108 HP E4418B/E4419B Programming Guide
STATus Subsystem
As the status reporting commands are orthogonal, the same commands
apply to all the registers. The registers are:
STATus:DEVice
STATus:OPERation
STATus:OPERation:CALibrating[:SUMMary]
STATus:OPERation:LLFail[:SUMMary]
STATus:OPERation:MEAsuring[:SUMMary]
STATus:OPERation:SENSe[:SUMMary]
STATus:OPERation:TRIGger[:SUMMary]
STATus:OPERation:ULFail[:SUMMary]
STATus:QUEStionable
STATus:QUEStionable:CALibration[:SUMMary]
STATus:QUEStionable:POWer[:SUMMary]
The following five commands operate on each of these registers. However,
to avoid duplication they are only listed once.
Keyword Parameter Form Notes Page
:CONDition? [query only] page 10-4
:ENABle <NRf>|<non-decimal numeric> page 10-5
[:EVENt?] [query only] page 10-4
:NTRansition <NRf>|<non-decimal numeric> page 10-6
:PTRansition <NRf>|<non-decimal numeric> page 10-7