prog.book : ch12trig.fm 3 Mon Feb 15 09:24:37 1999
TRIGger Subsystem
ABORt[1|2]
HP E4418B/E4419B Programming Guide 12-3
ABORt[1|2]
The ABORt command removes the specified channel from the
“wait-for-trigger” state and places it in the “idle” state. It does not affect
any other settings of the trigger system. When the INITiate command is
sent, the trigger system responds as it did before ABORt was executed.
If INITiate:CONTinuous is ON, then after ABORt the specified channel
immediately goes into the “wait-for-trigger” state.
Syntax
Example
ABOR This command places channel A in
the “idle” state.
ABOR
1
2