prog.book : ch7mem.fm 29 Mon Feb 15 09:24:37 1999
MEMory Subsystem
MEMory:TABLe:MOVE <string>,<string>
HP E4418B/E4419B Programming Guide 7-29
MEMory:TABLe:MOVE <string>,<string>
This command is used to rename a sensor calibration table or a frequency
dependent offset table.
Syntax
Parameters
Example
Error Messages
If either table name is invalid, error -224, “Illegal parameter value”
occurs.
If the first parameter does not match an existing table name, error -256,
“File name not found” occurs.
If the second parameter matches an existing table name or save/recall
register, error -257, “File name error” occurs.
Item Description/Default Range of Values
string
(1st parameter)
A string containing the existing table
name.
existing table
name
string
(2nd parameter)
A string detailing the new table
name. A maximum of 12 characters
can be used.
A to Z (uppercase)
a to z (lowercase)
0 - 9
_ (underscore)
MEM:TABL:MOVE "tab1","tab1a" This command renames a table
named tab1 to tab1a.
MEM
:TABL
:MOVE
string
string
,
Space
To Next Page
Loading...
