To Next Page

To Previous Page

prog.book : ch13unit.fm 6 Mon Feb 15 09:24:37 1999

UNIT Subsystem

UNIT[1|2]:POWer:RATio <ratio_unit>

13-6 HP E4418B/E4419B Programming Guide

UNIT[1|2]:POWer:RATio <ratio_unit>

This command is used on the HP E4419B to set the default units used

when inputting and outputting power ratio data.

• UNIT1:POWer:RATio sets the ratio measurement units for the

upper window. In addition, it also sets the ratio sufﬁx for any

SENSe1 command that requires but omits the ratio sufﬁx.

• UNIT2:POWer:RATio sets the ratio measurement units for the

lower window. In addition, it also sets the ratio sufﬁx for any

SENSe2 command that requires but omits the ratio sufﬁx.

Syntax

Parameters

Example

Reset Condition

On reset, the units are set to dB.

Item Description/Default Range of Values

ratio_unit The ratio measurement unit. The

default unit is dB.

PCT

UNIT1:POW:RAT DB This command sets the ratio

measurement units for the upper

window and the default units for

any relevant SENSe1 command to

dB.

UNIT :RAT

:POW

ratio_unit

Space

HP E4418B Programming Guide

Other manuals for HP E4418B