HP E4418B - [Sense[1]]|Sense2:Correction:cset[1]|Cset2 Node

prog.book : ch9sens.fm 14 Mon Feb 15 09:24:37 1999
SENSe Subsystem
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Node
9-14 HP E4418B/E4419B Programming Guide
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Node
This node is used to select the active sensor calibration table and the
active frequency dependent offset table.
Note If any of the CSET1 commands are used when an HP E-series
power sensor is connected, the error -241, “Hardware missing”
occurs.
The commands associated with this node are:
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2
[:SELect] <string>
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe
<Boolean>