prog.book : ch3calc.fm 8 Mon Feb 15 09:24:37 1999
CALCulate Subsystem
CALCulate[1|2]:LIMit Node
3-8 HP E4418B/E4419B Programming Guide
CALCulate[1|2]:LIMit Node
This node allows you to set the limits, on both the upper and lower
windows, which determine when a TTL logic level will be output on the
rear panel TTL Input/Output connector (pins 3 upper window and pin 4
lower window). The commands included in this section allow you to set
upper and lower level limits; query if there has been a failure; count the
number of failures; and clear the counter.
The commands asociated with this node are:
CALCulate[1|2]:LIMit:CLEar:Auto
CALCulate[1|2]:LIMit:CLEar[IMMediate]
CALCulate[1|2]:LIMit:FAIL?
CALCulate[1|2]:LIMit:FCOunt?
CALCulate[1|2]:LIMit:LOWer[:DATA]
CALCulate[1|2]:LIMit:UPPer[:DATA]
CALCulate[1|2]:LIMit:STATe
To Next Page
Loading...
Need help?
General
