To Next Page

To Previous Page

prog.book : ch2meas.fm 8 Mon Feb 15 09:24:37 1999

MEASurement Instructions

CONFigure[1|2] Commands

2-8 HP E4418B/E4419B Programming Guide

CONFigure[1|2] Commands

The CONFigure commands are used on the speciﬁed window to set,

• the expected power level value of the measurement.

• the resolution of the window.

• the channel(s) on which the measurement is to be made.

The CONFigure commands do not make the power measurement after

setting the conﬁguration. Use READ?, or alternatively use INITiate

followed by a FETCh? to make the measurement.

The CONFigure command also does the following to the channel(s) which

are in the speciﬁed window (the channel(s) in the window are speciﬁed in

the <source list> parameter):

INITiate:CONTinuous OFF Sets the power meter to make one trigger

cycle when INITiate is sent.

TRIGger:SOURce IMMediate Sets the power meter to make the

measurement immediately a trigger is

received.

TRIGger:DELay:AUTO ON Enables automatic delay before making the

measurement.

SENSE:AVERage:COUNt:AUTO ON Enables automatic ﬁlter length selection.

SENSE:AVERage:STATe ON Enables averaging.

HP E4418B Programming Guide

Other manuals for HP E4418B