To Next Page

To Previous Page

prog.book : ch9sens.fm 40 Mon Feb 15 09:24:37 1999

SENSe Subsystem

[SENSe[1]]|SENSe2:LIMit:CLEar:AUTO <Boolean>|ONCE

9-40 HP E4418B/E4419B Programming Guide

[SENSe[1]]|SENSe2:LIMit:CLEar:AUTO <Boolean>|ONCE

This command is used to control when the FCO (fail counter) is cleared of

any limit failures. The FCO is used to determine the results returned by

the [SENSe[1]]|SENSe2:LIMit:FAIL? query.

If ON is speciﬁed, the FCO is set to 0 each time a measurement:

• is initiated using INITiate[:IMMediate].

• is initiated using INITiate:CONTinuous ON.

• is measured using MEASure?

• is read using READ?

If OFF is speciﬁed, the FCO is not cleared by the above commands.

If ONCE is speciﬁed, the FCO is cleared only after the ﬁrst initialization

then starts accumulating any limit failures.

Syntax

Example

Reset Condition

On reset, both channels are set to ON.

SENS1:LIM:CLE:AUTO 1 This command switches on

automatic clearing of the FCO for

channel A.

LIM

:CLE

:AUTO

0|OFF

1|ON

Space

ONCE

SENS

SENS2

HP E4418B Programming Guide

Other manuals for HP E4418B