prog.book : title.fm viii Mon Feb 15 09:24:37 1999
About this Guide
viii HP E4418B/E4419B Programming Guide
About this Guide
Chapter 1: Power Meter Remote Operation
This chapter describes the parameters which configure the power meter
and helps you determine settings to optimize performance.
Chapter 2: MEASurement Instructions
This chapter explains how to use the MEASure group of instructions to
acquire data using a set of high level instructions.
Chapter 3: CALCulate Subsystem
This chapter explains how to use the CALCulate subsystem to perform
post acquisition data processing.
Chapter 4: CALibration Subsystem
This chapter explains how to use the CALibration command subsystem
to zero and calibrate the power meter.
Chapter 5: DISPlay Subsystem
This chapter explains how the DISPlay subsystem is used to control the
the selection and presentation of the windows used on the power meter’s
display.
Chapter 6: FORMat Subsystem
This chapter explains how the FORMat subsystem is used to set a data
format for transferring numeric information.
Chapter 7: MEMory Subsystem
This chapter explains how the MEMory command subsystem is used to
create, edit and review sensor calibration tables.
Chapter 8: OUTput Subsystem
This chapter explains how the OUTput command subsystem is used to
switch the POWER REF output on and off.
To Next Page
Loading...
