prog.book : ch7mem.fm 9 Mon Feb 15 09:24:37 1999
MEMory Subsystem
MEMory:CLEar Node
HP E4418B/E4419B Programming Guide 7-9
MEMory:CLEar Node
This node is used to remove the contents stored in the sensor calibration
tables, frequency dependent offset tables and save/recall registers. This
subsystem removes the data contents but does not affect the name of the
associated table or save/recall register.
The commands associated with this node are:
MEMory:CLEar:[NAME] <string>
MEMory:CLEar:TABLe
Note The contents cleared using these commands are non-recoverable.
To Next Page
Loading...
