prog.book : ch8out.fm 2 Mon Feb 15 09:24:37 1999
OUTput Subsystem
OUTPut Subsystem
8-2 HP E4418B/E4419B Programming Guide
OUTPut Subsystem
The OUTPut command subsystem is used to switch on and off the
POWER REF output and control the rear panel TTL outputs. The.TTL
Outputs can be used to determine when a predefined limit in either, or
both, windows has been exceeded.
Keyword Parameter Form Notes Page
OUTPut
:ROSCillator
[:STATe] <Boolean> page 8-3
:TTL[1|2]
:ACTive HIGH|LOW page 8-4
:FEED <String> page 8-5
:STATe <Boolean> page 8-7
To Next Page
Loading...
