HP E4418B Programming Guide

prog.book : chapter1.fm 10 Mon Feb 15 09:24:37 1999
Power Meter Remote Operation
Configuring the Remote Interface
1-10 HP E4418B/E4419B Programming Guide
1. This command is accepted but has no active function.
2. This command is not an original HP 438A command. However, it can be used to
set the measurement speed to 20 or 40 readings/sec in HP 438A mode. See
SENSE:SPEED for more details.
3. This command is not an original HP 438A command. However, it can be used to
terminate the HP 438A language and select the SCPI language. Note that it is
recommended that the instrument is Preset following a language switch.
4. This command is not an original HP 437B command. However, it can be used to
allow the last measurement result to be transmitted. This is equivalent to
sending the power meter talk address in HP-IB mode to fetch the last reading
(provided no query is pending).
OC1
Reference oscillator on
OS
Enter offset value
PR
Preset
RA
Auto range
RC
Recall instrument configuration
RH
Range hold
RL0
Exit from relative mode
RL1
Enter relative mode (take new reference)
RM
Set measurement range
RV
Read service request mask
SM
Status message
SPD 20|40
2
20 or 40 readings/sec
ST
Store (save) power meter configuration
SYST:LANG SCPI
3
Selects SCPI language
TK?
4
Last measurement result transmitted
TR0
Trigger hold
TR1
Trigger immediate
TR2
Trigger with delay
TR3
Trigger free run
ZE
Zero
@1
Prefix for status mask
?ID
Identification query
Command Description

HP E4418B Specifications

General

Brand	HP
Model	E4418B
Category	Measuring Instruments
Language	English