HP E4418B - Page 385

prog.book : ch11syst.fm 2 Mon Feb 15 09:24:37 1999
SYSTem Subsystem
SYSTem Subsystem
11-2 HP E4418B/E4419B Programming Guide
SYSTem Subsystem
The SYStem command subsystem is used to return error numbers and
messages from the power meter, preset the power meter, select the remote
interface type (GPIB, RS232 or RS422), set the GPIB address, set the
command language and query the SCPI version.
At a lower level you can use SYSTem:COMMunicate:SERial:CONTrol to
set the DTR and RTS signal lines, and
SYSTem:COMMunicate:SERial:CONTrol[:RECeive] and TRANsmit
to set baud rate, parity, word length and other serial interface controls.]
Keyword Parameter Form Notes Page
SYSTem
:COMMunicate
:GPIB
[:SELF]
:ADDRess <numeric_value> page 11-3
:SERial
:CONTrol
:DTR ON|OFF|IBFull page 11-5
:RTS ON|OFF|IBFull page 11-6
[:RECeive]
:BAUD <numeric_value> page 11-7
:BITs <numeric_value> page 11-9
:PACE XON|NONE page 11-11
:PARity
[:TYPE] EVEN|ODD|ZERO|ONE|NONE page 11-12
:SBITs <numeric_value> page 11-14
:TRANsmit
:AUTO? [query only] page 11-15
:BAUD <numeric_value> page 11-16
:BITs <numeric_value> page 11-18
:ECHO ON|OFF page 11-19
:PACE XON|NONE page 11-21
:PARity
[:TYPE] EVEN|ODD|ZERO|ONE|NONE page 11-22
:SBITs <numeric_value> page 11-24
:ERRor? [query only] page 11-26
:LANGuage <character_data> page 11-27
:LOCal page 11-28
:PRESet [event; no
query]
page 11-29
:REMote page 11-32
:RINTerface GPIB|RS232|RS422 page 11-33
:RWLock page 11-34
:VERSion? [query only] page 11-35