prog.book : chapter1.fm 50 Mon Feb 15 09:24:37 1999
Power Meter Remote Operation
Setting the Range, Resolution and Averaging
1-50 HP E4418B/E4419B Programming Guide
Filter Length
You specify the filter length using the following command:
[SENSe[1]]|SENSe2:AVERage:COUNt <numeric_value>
The range of values for the filter length is 1 to 1024. Specifying this
command disables automatic filter length selection. Increasing the value
of the filter length reduces measurement noise. However, the time to take
the measurement is increased.
To Next Page
Loading...
