447
Table 300 Configuration items
Item Description
Call Forwarding
Configure call forwarding:
• Enable.
• Disable.
By default, call forwarding is disabled.
After you enable a call forwarding, enter the corresponding forwarded-to number:
• The Forwarded-to Number for Call Forwarding no Reply—Enter the
forwarded-to number.
• The Forwarded-to Number for Call Forwarding Busy—Enter the
forwarded-to number.
• The Forwarding Unconditional—Enter the forwarded-to number.
• The Forwarded-to Number for Call Forwarding Unavailable—Enter the
forwarded-to number.
Call Hold
Configure call hold:
• Enable.
• Disable.
By default, call hold is disabled.
After call hold is enabled, set the
Max Time Length the Held Party Can Wait
parameter as needed.
IMPORTANT:
The Max Time Length the Held Party Can Wait is only applied to the held party of a
call, that is, the receiver of call hold.
Call Transfer
Configure call transfer:
• Enable.
• Disable.
By default, call transfer is disabled.
Call hold must be enabled before you can configure call transfer.
After call transfer is enabled, you can set the
Call Transfer Start Delay
parameter
as needed.
Three-Party
Conference
Configure three-party conference:
• Enable.
• Disable.
By default, three-party conference is disabled.
The three-party conference function depends on the call hold function. Therefore,
you must enable the call hold function before configuring three-party conference.
Call Waiting
Configure call waiting:
• Enable.
• Disable.
By default, call waiting is disabled.
After call waiting is enabled, configure the following parameters as needed:
• Number of Call Waiting Tone Play Times.
• Number of Tones Played at One Time.
• Interval for Playing Call Waiting Tones.
By default, two call waiting tones are played once, and if the value of
Number of
Tones in a Call Waiting Tone
is greater than 1, the
Interval for Playing Call
Waiting Tones
is 15 seconds.
To Next Page
Loading...
