135
Item Description
CPE
Interface.
Set the CPE connection interface. The CPE sends inform packets carrying the IP
address of this interface to make the ACS establish a connection with the CPE
using this IP address.
Configuration guidelines
TR-069 configuration through ACS is of higher priority than that through Web. You cannot use a
configuration mode to modify parameters configured through a configuration mode with a higher
priority.
To remove the configuration of a parameter, select the parameter, clear the value you entered, and
click Apply.
Upgrading software
CAUTION:
Software upgrade takes a period of time. During software upgrade, do not perform any operation on
the Web interface. Otherwise, software upgrade might be interrupted.
A system software image, also known as the "boot file," is an application file used to boot the device.
A main system software image is used to boot a device and a backup system software image is used
to boot a device only when the main system software image is unavailable.
Software upgrade allows you to get a target application file from the current host and set the file as
the system software image (or as the main or backup system software image on the devices that
support main/backup system software image) to be used at the next boot.
Upgrading software (for the MSR900/MSR20-1X)
1. From the navigation tree, select System Management > Software Upgrade.
The software upgrade configuration page appears.
2. Configure software upgrading as described in Table 199.
3. Click Apply.
Figure 522
Software upgrade configuration page
To Next Page
Loading...
Need help?
General
