412
a. Type 10 for Node ID.
b. Type play-welcome for Description.
c. Select Enable for Play Voice Prompts; select welcome from the Voice Prompts list.
d. Select Terminate the call for Key#.
e. Click Apply.
For other settings, see Configuring Router B.
Verifying the configuration
1. Dial 300 at Telephone A.
Router B plays the audio file welcome.wav.
2. Dial #.
The call is terminated.
Configure an immediate secondary call on a service node
Network requirements
As shown in Figure 805, configure an IVR access number and service node functions on Router B to
meet the following requirements.
• After the subscriber dials 300 (the IVR access number) from Telephone A, Telephone B rings.
• If the subscriber dials a wrong number at Telephone A, Router B plays the audio file
input_error.wav.
• If no number is dialed at Telephone A within the timeout time, Router B plays the audio file
timeout.wav.
Figure 805 Network diagram
Configuration procedure
1. Configure Router A: See Configuring Router A.
2. Configure Router B:
# Configure a service node.
Select Voice Management > IVR Services > Advanced Settings from the navigation tree,
select the Configure Service Node tab, and click Add to access the following page.
To Next Page
Loading...
