414
b. Type 300 for Number.
c. Select call500 from the Bind to Menu list.
d. Click Apply.
For other settings, see Configuring Router B.
Verifying the configuration
Dial 300 at Telephone A. Telephone B rings.
Configure a secondary call on a service node
Network requirements
As shown in Figure 808, configure an IVR access number and service node functions on Router B to
meet the following requirements.
• After the subscriber dials 300 (the IVR access number) from Telephone A, Router B plays the
audio file bye.wav, and then terminates the call.
• If the subscriber dials a wrong number at Telephone A, Router B plays the audio file
input_error.wav.
• If no number is dialed at Telephone A within the timeout time, Router B plays the audio file
timeout.wav.
Figure 808 Network diagram
Configuration procedure
1. Configure Router A: See Configuring Router A.
2. Configure Router B:
# Configure a service node.
Select Voice Management > IVR Services > Advanced Settings from the navigation tree,
select the Configure Service Node tab, and click Add to access the following page.
To Next Page
Loading...
Need help?
General
