HPE FlexNetwork MSR Series User Manual

243
Task Remarks
Configuring an SNMP community
Required.
Configuring the SNMP trap function
Optional.
Allows you to configure that the agent can send SNMP traps to
the NMS, and configure information about the target host of the
SNMP traps.
By default, an agent is allowed to send SNMP traps to the NMS.
Displaying SNMP packet statistics
Optional.
Configuring SNMPv3
Task Remarks
Enabling the SNMP agent function
Required.
The SNMP agent function is disabled by default.
IMPORTANT:
If the SNMP agent function is disabled, all SNMP agent-related
configurations are removed.
Configuring an SNMP view
Optional.
After creating SNMP views, you can specify an SNMP view for
an SNMP group to limit the MIB objects that can be accessed
by the SNMP group.
Configuring an SNMP group
Required.
After creating an SNMP group, you can add SNMP users to the
group when creating the users. Therefore, you can realize
centralized management of users in the group through the
management of the group.
Configuring an SNMP user
Required.
Before creating an SNMP user, you need to create the SNMP
group to which the user belongs.
Configuring the SNMP trap function
Optional.
Allows you to configure that the agent can send SNMP traps to
the NMS, and configure information about the target host of the
SNMP traps
By default, an agent is allowed to send SNMP traps to the NMS.
Displaying SNMP packet statistics
Optional.
Enabling the SNMP agent function
1. Select Advanced > SNMP from the navigation tree to enter the SNMP configuration page, as
shown in Figure 253.
On the upp
er
part of the page, you can select to enable or disable the SNMP agent function and
configure parameters such as SNMP version.
On the lower part of the page, you can view the SNMP statistics, which helps you understand
the running status of the SNMP after your configuration.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English