87
Local MAC authentication configuration example
Network requirements
As shown in Figure 69, perform MAC authentication on the client.
Figure 69 Network diagram
Configuration procedure
1. Configure a wireless service:
a. Select Interface Setup > Wireless > Access Service from the navigation tree.
b. Click Add.
Figure 70 Creating a wireless service
c. Select the radio unit 1.
d. Set the service name to mac-auth.
e. Select the wireless service type clear.
f. Click Apply.
2. Configure local MAC address authentication:
After you create a wireless service, you enter the wireless service configuration page. You must
perform security setup when configuring MAC authentication.
To Next Page
Loading...
