HPE FlexNetwork MSR Series User Manual

196
Recommended configuration procedure
Configuring the DHCP server
Task Remarks
Configuration guidelines
1. If multiple VLAN
interfaces sharing
one MAC address
request IP addresses
using DHCP, the
DHCP server cannot
be a Windows
2000 server or a
Windows 2003
server.
2. To remove a DHCP
server group that is
associated with
multiple interfaces,
cancel the
associations first.
Enabling DHCP
Required.
Enable DHCP globally.
Disabled by default.
Configuring the DHCP server on an
interface
Optional.
For detailed configuration, see "
Configuring DHCP interface setup
."
Enab
led b
y default.
IMPORTANT:
The DHCP server configuration is supported only on a Layer 3
Ethernet interface (or subinterface), virtual Ethernet interface,
VLAN interface, Layer 3 aggregate interface, serial interface, ATM
interface, MP-group interface, or loopback interface.
Configuring a static address pool for the
DHCP server
Required.
An address pool can be either static or dynamic, but not both.
IMPORTANT:
When a DHCP client tries to obtain an IP address through a DHCP
relay agent, an IP address pool on the same network segment as
the DHCP relay agent interface must be configured. Otherwise,
the DHCP client fails to obtain an IP address.
Configuring a dynamic address pool for
the DHCP server

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English