151
Managing WiNet
To manage WiNet members, make sure the port that connects your host to the administrator permits
packets of the management VLAN. Select WiNet from the navigation tree to enter the default WiNet
Management page.
Figure 536 WiNet management page
On the WiNet Management page, you can perform these operations:
1. Set the refresh period for automatic refreshing of the WiNet topology diagram. Or you can
select Manual for Refresh Period and click Refresh to display the latest WiNet topology
diagram.
2. Click Collect Topology.
After that the administrator starts to collect topology information. Note that, in addition to
manual topology collection, the system automatically collects topology information every
minute.
3. Click Network Snapshot to save the current WiNet topology as the baseline topology. The
baseline topology is used to show changes in network topology at different time points.
4. Click Initialize Topology to clear the stored baseline topology and cookies.
5. Click Open AuthN Center to configure a RADIUS server for security authentication on the
administrator device. The administrator device automatically generates a guest user guest and
its password and updates the user and password at 24:00.
6. After the authentication center starts up, the Open AuthN Center button changes to Close
AuthN Center. Click the Close AuthN Center to remove the RADIUS server and the guest
user.
To Next Page
Loading...
Need help?
General
