177
Configuring user-based load sharing
You can configure user-based load sharing through the Web interface.
Overview
A routing protocol can have multiple equal-cost routes to the same destination. These routes have
the same preference, and are all used to accomplish load sharing if no route with a higher preference
is available.
The device supports user-based load sharing based on the user information (source IP addresses)
of packets.
Configuration procedure
1. Select Advanced > User-based-sharing from the navigation tree.
The user-based load sharing page appears.
Figure 189 User-based load sharing
2. Click the icon of an interface.
The Modify configuration page appears.
Figure 190 Modifying configuration
3. Configure the parameters as described in Table 100.
Table 100 Configuration items
Item Description
Interface
This field displays the name of the interface on which user-based load sharing is
configured.
Status of
user-based-sharing
Set whether or not to enable user-based load sharing on the interface.
To Next Page
Loading...
Need help?
General
