HPE FlexNetwork MSR Series User Manual

136
Configuring a DMZ host
Creating a DMZ host
1. From the navigation tree, select NAT Configuration > NAT Configuration.
2. Click the DMZ HOST tab.
The DMZ host configuration page appears.
Figure 142 Creating a DMZ host
3. Configure the parameters as described in Table 86.
4. Click Add.
Table 86 Configuration items
Item Description
Host IP Address Specify the internal IP address of a DMZ host.
Global IP Address Specify the external IP address of a DMZ host.
Enabling DMZ host on an interface
From the navigation tree, select NAT Configuration > NAT Configuration and click the DMZ HOST
tab to enter the DMZ host configuration page as shown in Figure 142. Y
ou can
enable or disable DMZ
host on interfaces.
• The icon indicates that DMZ host is disabled on the corresponding interface. Click the
Enable link next to the interface to enable DMZ host on the interface.
• The icon indicates that DMZ host is enabled on the corresponding interface. Click the
Disable link next to the interface to disable DMZ host on the interface.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English