247
Figure 257 Adding rules to an SNMP view
You can also click the icon corresponding to the specified view on the page as shown in Figure
254, and then you can enter the page to modify the view.
Configuring an SNMP community
1. Select Advanced > SNMP from the navigation tree, then click the Community tab to enter the
page as shown in Figure 258.
Figure 258
Con
figuring an SNMP community
2. Click Add to enter the Add SNMP Community page.
Figure 259 Creating an SNMP Community
3. Configure the SNMP community, as shown in Table 124.
To Next Page
Loading...
