HPE FlexNetwork MSR Series

145
3. Configure the log host as described in Table 203.
4. Click Apply.
Table 203 Configuration items
Item Description
IPv4/Domain
Set the IPv4 address or domain name of the log host.
Loghost IP/Domain
IPv6
Set the IPv6 address of the log host.
Loghost IP
Setting buffer capacity and refresh interval
1. Select Other > Syslog from the navigation tree.
2. Click the Log Setup tab.
The syslog configuration page appears, as shown in Figure 531.
Figure 531 Log setup
3. Configure buffer capacity and refresh interval as described in Table 204.
4. Click Apply.
Table 204 Configuration items
Item Description
Buffer Capacity Set the number of logs that can be stored in the log buffer.
Refresh Interval
Set the refresh interval of log information.
You can select manual refresh or automatic refresh:
• Manual—Click Refresh to refresh the Web interface.
• Automatic—Select to refresh the Web interface every 1 minute, 5 minutes,
or 10 minutes.