IAI TB-02 - Axis Number Change; Load Cell Calibration

3. Operation of CON Related Controllers
92
Touch [Yes].
Touch [No], and the controller will not be rebooted and the
screen returns to the previous.
Caution: If the controller is not restarted, the parameters that have been rewritten to their factory
settings do not translate to the factory-set operations.
The factory settings will become effective once the controller is restarted or power is
reconnected.
3.16.2 Axis Number Change
Touch [Change axis No.] in Other setting window to display Axis No. setting screen.
You can set a value between 0 and 15.
Set a desired axis number and then touch [ENT].
Touch [Execute].
3.16.3 Load Cell Calibration
Loadcell calibration can be conducted on an actuator equipped with a loadcell. (SCON-CB)
Touch [Load cell calibration] in Other setting window to display Load cell calibration screen.
Touch [Yes].