3. Operation of CON Related Controllers
85
3.12.1 Jog/Inching Operation
[Jog/Inching Operation]
You can perform jog/inching operation.
Operation on the jog/inching screen
Jog vel. / Inching :Select either of 1, 10, 30, 50 or 100mm/s of JOG speed or 0.01, 0.10,
0.50, 1.00, 5.00mm of inching distance, and JOG operation with the
selected speed or inching operation with the selected distance can
be conducted. The circle (radio button) on the selected one will be
marked with a black dot.
[Servo] : Touching [Servo] while the servo is OFF turns on the axis servo and
becomes lit.
Touching [Servo] while the servo is ON turns off the axis servo and
becomes unlit.
[Homing] : Touching [Homing] while home return is not yet completed causes
the axis to return home and becomes lit.
[Brake rel.] : For an actuator equipped with a brake, touch [Brake rel.] and the
brake gets compulsorily released and the circle turns on.
Touch [Brake rel.] again and the brake works and the circle turns off.
[BACK(-)], [FW(+)] : When JOG operation is selected, while touching them, the axis
moves in the set speed. When inching operation is selected, every
time touching them, the axis moves for the set distance.
[BACK(-)] performs JOG operation in negative direction.
[FW(+)] performs JOG operation in positive direction.
In inching operation, touch and hold them for two seconds, and JOG
operation will be performed in 1mm/sec. The speed increases in
every 1 second afterwards.
Caution: An axis could drop if the brake compulsory release is performed while the servo is off
when the axis is installed in the vertical orientation.
Caution: Operation with JOG Switch on Front Panel of RCON
If TB-02 gets disconnected from the controller in the condition that this window is open,
JOG switch operation will get disabled.
To Next Page
Loading...